GENESIS 1 READ ALOUD MOD

On the first day, God commanded light into existence. God’s spirit moved upon the water’s surface and He created the heavens and the Earth. The text describes how the Lord spoke all things into being except humankind, whom He created in his image.īefore the creation of the earth, the universe was a dark void with water being the only substance in existence. Finish re-assembling the Genesis.Genesis 1 consists of 31 verses and provides an overview of how the world was created in 6 days.You can combine the ground wires if you need to. After they’re mounted, simply run the wires and solder them in.

Make sure to mount them in the same place I did, as close to the edge of the top cover as possible, otherwise you won’t be able to use the power base converter! Mine are off-centered (cause I’m not a very good craftsman), but you’ll want to mount yours as low as you can, to make sure it clears the Power Base Converter! If you chose the RCA audio or heaphone jack method, you must now drill holes in the back of the top cover.If you insist on cutting plastic, please note my original method below and place the audio jacks where they won’t interfere with adapters: My opinion aside, it’s your console and you can do as you wish. If not, using the “extension cable” method would be an overall better choice. If you have the right tools, removing the RF adapter and utilizing the factory holes are the best method. I strongly recommend that you do not cut any plastic on your consoles.

GENESIS 1 READ ALOUD MOD

PLEASE NOTE!!!: My views on this mod have changed since I wrote it.

Replace the metal cover and make sure the cable is run through as shown here (obviously only route it through the “ext” port if you’re using that method): If you used the headphone extension cable method, skip to step #11.

Otherwise route it to the same area, but not through the hole: If you don’t plan on mounting jacks, you can use a headphone extension cable and run the jack-end of the cable through the “EXT” port first (arrow 2).

Make sure the cable is wrapped around the side exactly as arrow 1 demonstrates below.

Cover the soldered area with a piece of tape and run the cable along the side of the board:.

Then solder the wires exact as you see here:

Strip your wire (or the headphone extension cable) and make sure you leave it long enough so there’s plenty of room to run the cable out the back of the Genesis.

This is to make sure the wires you’re about to solder won’t interfere with any exposed pins:

Put some non-conductive tape on the area above the chip, exactly as shown here.

Notice the location of the “473” and make sure yours lines up the same way (the actual number 473 may be upside down on your Genesis…I mean it’s physical location on the board).

Flip the genesis motherboard over and find the bottom part of that chip.

If the Sony chip is there, you can proceed: I suggest checking out this page to find a different way to improve the sound of your Genesis.

If the chip isn’t there, you have a rare version of the model 1 Genesis that has a different motherboard revision and you won’t be able to do this mod.

Take the Genesis motherboard out and locate this chip.

Honestly though, there’s much less chance of damage if you just cut the wire and add some cheap connectors (these pictures show butt connectors): You can try to leave it connected, or try to remove the LED and then re-glue it afterwards. Personally, I prefer to cut the LED cable in the middle and add butt connectors or jumper connectors, but it’s up to you.

First, take the Genesis apart and be careful not to damage the LED power light.

This guide shows a few different methods of mounting the audio jacks, but all start the same:

Genesis 1 read aloud